It could be a bedroom door that lets the dog enter then the room then traps your faithful friend.
Bedroom door won t stay open.
The problem can result from the door and it s hardware or it can result from settling of the building.
Last there is the bedroom door which slowly swings closed unless we open it fully.
When a door slams shut it can be a pesky problem on a daily basis.
To fix a bent hinge open the door and shim underneath to support its.
Most likely the door is not plumb meaning that the hinges do not line up as they should.
Why won t the door stay open on its own.
With a little research you can figure out what is causing your door to be so difficult.
I had a pesky door in my bathroom that kept closing on its own.
Rather than keeping a brick in front of it i fixed the problem at the hinge.
When a door won t stay put.
The door frame and door are tilted and the unbalanced weight of the door causes the door to close on its own.
Begin with the bottom pin and work up.
How to fix a door that won t stay open.
Whether it swings closed or open if it moves on its own it is not properly adjusted.
When a door won t stay open or closed by itself that is when it tends to swing slowly closed after it has been left open or when it swings slowly open and won t stay in the partly closed.
Angle the blade of a large flathead screwdriver against the tip of the hinge pin and tap the base of the screwdriver to push the pins upward and out.
A door that won t stay put when part way or all the way open can be annoying.
Place it on a hard surface and whack it in the middle with a hammer.
How to fix a door that won t stay open.
Rather than remove and rehang it try removing one of the hinge pins.
We all have an interior door that won t stay partially open or closed when we want it to.
Rather than trip over a brick to prop a door open that won t stay open you can fix it with a few minutes of time and a few tools.
This should give it a slight bend which will add tension to the hinge when you re install it.
When a door won t stay open the casing is probably leaning slightly in the wall frame.